1x 5.8G 14dBi Triple Feed Patch Array Antenna (RHCP/LHCP SMA Male)
The Triple Feed Patch Array antenna is a directional circularly polarized antenna based on the original Triple Feed Patch antenna. It uses an array of seven coupled patches, resulting in significantly higher gain. This antenna is not recommended for general FPV use since the beam width is rather narrow, but it should perform very well for long-range flying.
Good radiation efficiency. Most FR4-based patches have terrible efficiency because FR4 is very lossy at 5.8 GHz. Additionally, most array antennas have higher losses in the feed network. This design uses coupled patches to keep the feed network simple and reduce these losses.
Exceptionally good axial ratio, not just directly perpendicular to the patch but also off-center.
High gain, though not as high as the theoretical gain of an array with 7 elements. This is because maximizing the gain would result in high sidelobes and a poor axial ratio.
Very low sidelobes, almost all energy is concentrated in the main lobe. This increases the width of the main lobe, at the expense of some gain.
3DPOWER 5.8G 14dBi Triple Feed Patch Array Antenna (RHCP/LHCP SMA Male)